RightWay GPS Navigator RW 430 Guia do Utilizador descarregar pdf (Página 55)

GPS RTK Base GPS Receiver User Guide 53

Automatically Setting up a Mobile Base Station Using AutoBase Technology 7

6. The antenna type, antenna height, and measurement method

used in the previous setup of this base station are applied.

CAUTION – If the antenna height is different to the previous setup, then

you must enter the corrected height for the antenna (using the keypad

and display) before starting measurements. Failure to achieve the correct

antenna height position for the antenna results in errors in heights in

subsequent measurements.

7. The receiver begins generating RTK CMR+ messages.

8. The RTK corrections begin streaming on the radio or Lemo port

defined in the application file.

Scenario Four: Repeat visit to a site with AutoBase Warning

turned on

The following actions occur when you repeat a base station setup on a

point, and the AutoBase Warning is turned on:

1. You turn on the receiver.

2. The receiver begins tracking satellites.

3. The receiver determines the current position.

4. The receiver reviews the base station positions stored in the

receiver.

5. The receiver finds a base station position that corresponds to the

current position.

CAUTION – If there are two or more base positions within a 50 meter

radius of your current position, the receiver will make the most recently

created base position file active.

6. Since a base station position is found, the AutoBase warning does

not appear.

7. The receiver loads the previous base information.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 93 94

Sem comentários

RightWay GPS Navigator RW 430 Guia do Utilizador Página 55